Okay, This is the base of your basic run of the mill Honda light Bulb.
(From 95 VFR-750)

And, This is the base of the basic H4 light Bulb. Notice the two smaller tabs are in different positions than the Honda Bulb.

#1

First, Twist off these
2 little tabs.

#2

Get a 2 inch nail,

(With no head on it) or a 2 inch peice of clothes hanger wire.

#3

Bend up the two tabs, Then lay the nail or wire evenly across the base.

#4

With the wire in place, bend up the smaller tabs over the wire to hold it in place.

#5

Here's another angle to Look at...

#6

These are shots out of the Clymer manual. I'm trying to show the notches where the wire will sit, when finished.

#7

The installed wire will set in these notches and rest the bulb exactly where the stock bulb would sit.

#8

This is a shot of my bike with the new bulb installed, Notice the wire is sitting perfectly in the grooves where the old bulb would sit. This was taken with the rubber boot removed.

Click to go to

The

Tenzo Lights

page

Click to go to

the ST1100

Fairing removal

Page

Go to Jeff's

GSXR Page

(For Sale)

Go to Jeff's bike page

Go to Steve LaMonica's

Dash Page

Go to Steve LaMonica's

Geza Cover Page

Go to VFR 750 HomePage